Wood & steel frame
Wrought iron
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateTrusted Gate Motor & Opener for Paradise Homeowners
A gate that won’t open is a driveway you can’t use, and in Paradise that usually shows up at the worst time – the morning you’re leaving for work, or the night you’re coming home with groceries melting in the trunk. We service and install gate motors and openers for homeowners across Paradise, from the older stretches near Flamingo Road to the newer streets off Warm Springs. Our technicians have up to 25 years of experience, and we’re certified on nine major brands, so we’ve likely seen your operator before. Same-day repair is often possible when you call early, and a live person answers the phone around the clock. Call (888) 292-7536 and tell us what the gate is doing.
What Our Gate Motor & Opener Service Includes
Every motor job starts with the same question: is the operator failing, or is the gate itself the problem? A binding hinge, a bent track, or a post that’s shifted a quarter inch can make a perfectly good motor act like it’s dying. We check the gate first, then the operator, so you don’t pay for a motor you didn’t need.
Motor Installation
Motor installation means fitting a new operator to your existing gate or a new one, matching the arm or slide mechanism to the gate’s weight, width, and how often it opens. You need it when a motor has failed past repair, when you’re automating a gate for the first time, or when the old unit was undersized for the gate and wore out early. We measure the gate, confirm the power source, and mount the operator so the gate travels smooth and stops where it should. This is scheduled work, not same-day – we measure first, then give you a written price before anything gets ordered.

Motor Repair
Motor repair covers everything from a dead control board to a slipping clutch to a chain that’s jumped the sprocket. You need it when the gate moves partway and stops, makes a grinding noise, or opens fine but won’t close. We diagnose on site with a multimeter and a load test, then tell you plainly whether the fix is a $90 part or a replacement – and we repair rather than replace whenever repair is the honest answer.

Linear Motor
Linear operators are common on residential driveways around Paradise, and they’re reliable until the limit switches drift or the battery in the control box goes soft. You need service when the gate reverses for no reason, stops short of fully closed, or the keypad stops responding. We service Linear units regularly and know the failure points – the board, the receiver, and the safety edge connections. If it’s a simple adjustment, that’s what we do.

Slide Motor
Slide motors drive a gate that rolls along a track instead of swinging, which is common on wider driveways where a swing gate won’t fit. You need help when the gate drags, the track has debris or a bent section, or the motor strains at one end of its travel. We check the track, the rollers, and the operator together, because a slide gate that binds will burn out a good motor fast. On-site welding lets us fix a damaged track stop or mount without hauling anything away.
Intercom Integration
Intercom integration connects your gate opener to a call box or entry station so you can talk to a visitor and buzz them in without walking out. You need it when you want deliveries, guests, or service people to reach you from the gate instead of the front door. We wire the intercom into the operator’s access control so the release works reliably and the wiring is protected from the sun and weather. This is planned work – we’ll walk the run and quote it before we start.
Battery Backup
Battery backup keeps your gate working through a power outage, which matters more than people think when the gate is your only way in or out. You need it if your operator has no backup, or if the existing battery is old and no longer holds a charge. We test the battery under load, replace it when it’s spent, and confirm the operator switches over cleanly when the power drops. In Paradise’s summer heat, batteries fade faster than the label suggests, so a load test beats a guess.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Brands We Service for Gate Motor & Opener
We’re certified to service nine major gate brands, and three of them come up most often on Paradise driveways. LiftMaster operators are everywhere on residential gates, and we know their control boards, receivers, and the way their safety sensors drift out of alignment over time. DoorKing units show up on larger residential and shared-driveway gates, and we understand their loop and keypad wiring well enough to troubleshoot without guessing. Mighty Mule is a common DIY-installed brand, and we’ve fixed plenty of them where the original install left the arm mounted too high or the stops set wrong.
We also service FAAC, BFT, Linear, Viking, Ghost Controls, and Elite equipment, and each one has its own wear pattern – where the gears go soft, where the limit switches wander, where the housing lets water in. We don’t guess at a brand we don’t know; we look it up, test it, and tell you what we find. Whether you have a LiftMaster on a swing gate or a DoorKing running a slide gate, we can help, and if it’s a brand we don’t recognize we’ll say so before we touch it.
Signs You Need Gate Motor & Opener Right Now
Some gate problems are annoyances. Others are the gate telling you it’s about to quit entirely. Here’s what to watch for:
- The gate reverses before it closes. That’s usually a safety sensor or a limit switch, and it’s a sign the operator is getting a false signal. Left alone, it can leave the gate open all night.
- The motor runs but the gate doesn’t move. A slipping clutch, a stripped gear, or a broken chain – any of these means the operator is working and the gate isn’t. It won’t fix itself, and running it that way can damage the motor.
- Grinding or squealing when it moves. Metal-on-metal noise points to worn gears or a dry track. Catch it early and it’s a repair; wait and it’s a replacement.
- The gate moves slowly or strains. A motor working harder than it should is often fighting a binding hinge or a sagging post. The motor may be fine – the gate is the problem.
- The remote works sometimes and not others. A weak receiver, a dying battery in the remote, or interference from a nearby device. Easy to test, and usually an easy fix.
Our Gate Motor & Opener Process – Step by Step
- 1
We answer the phone and ask what the gate is doing. Not a voicemail, not a call center – a live person who knows gates. We’ll ask whether it’s a swing or slide gate, what brand the operator is, and whether the gate moves at all, so we show up with the right tools and a good idea of what we’re walking into.
- 2
We diagnose on site before we quote. Multimeter on the power, load test on the motor, a physical check of the hinges, track, and posts. We watch the gate run and listen to it. Half the time the “motor problem” is a gate problem, and we’d rather find that out before you pay for a motor.
- 3
We give you a written price before any work starts. Line by line, parts and labor, so you know what you’re approving. No surprises at the door, no numbers that change once the truck is in the driveway.
- 4
We repair on site and weld on site. If a bracket is cracked or a mount has shifted, we weld it in your driveway rather than hauling the gate off. Most repairs are done in a single visit, and we clean up after ourselves.
- 5
We test it with you watching and back it with the 90-Day Done Right Promise. The gate opens, closes, reverses on the safety edge, and runs smooth before we leave. If something isn’t right within 90 days, one call brings us back – the promise is in writing on every job.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Motor & Opener Cost in Paradise?
Gate motor and opener work in Paradise generally runs from about $150 for a simple sensor or limit-switch fix up to $900 or more for a full motor replacement, depending on the operator and the gate.
| Job | Typical Range |
|---|---|
| Diagnostic visit (waived if you approve the repair) | $0 – $95 |
| Limit switch, sensor, or remote receiver repair | $150 – $280 |
| Battery backup replacement | $180 – $350 |
| Control board or gear replacement | $280 – $550 |
| Full swing or slide motor replacement (operator included) | $650 – $1,200 |
| Intercom integration (wiring and entry station) | $400 – $900 |
What moves the number: the brand and model of operator (a LiftMaster residential unit costs less than a heavy-duty DoorKing), whether the gate itself needs repair before the motor will work right, and how far the power and low-voltage runs have to travel. To avoid overpaying, get the diagnosis in writing before you approve anything, and ask whether the gate was checked before the motor was condemned. A free second opinion on any written estimate is always available if you want one.
Our free estimate includes the on-site diagnosis, a written line-item price, and a plain answer on whether repair or replacement is the honest call. You approve the price before we start – no work begins until you say go. We also take $40 off any repair over $200, there’s no trip charge inside the county, and seniors and veterans get a permanent 10% discount.
Gate Motor & Opener Near Paradise – Our Service Area
We serve Paradise and the surrounding communities, including Winchester, Whitney, Spring Valley, Enterprise, Henderson, Sunrise Manor, Summerlin, Las Vegas, North Las Vegas, Boulder City, and Sandy Valley. Response times depend on where you are and how busy the day is – Paradise and Winchester are usually quick, and the outlying areas like Sandy Valley we schedule with a clear window. For nearby coverage, see our Gate Motor & Opener in Winchester page or our Gate Motor & Opener in Whitney page. If you’re not sure whether you’re in our area, call and ask – we’ll tell you straight.
Serving Paradise, NV – Our Local Coverage Area
We serve Paradise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Gate Motor & Opener in Paradise
A gate motor and opener is the operator unit that automatically opens and closes your driveway gate, usually with a remote, keypad, or intercom. It mounts to the gate or the post and drives the gate along a track or on a swing arm. The operator includes the motor, the control board, the safety sensors, and the receiver that picks up your remote. When any of those parts fail, the gate stops working even if the motor itself is fine.
Most repairs are done in a single visit, usually one to two hours on site. A sensor adjustment or remote receiver swap can be under an hour; a control board or gear replacement takes longer. Full motor replacement and intercom integration are scheduled jobs – we measure, order the right operator, and come back to install, which is typically a half-day. We’ll give you a time window and stick to it.
Most repairs in Paradise run $150 to $550, and a full motor replacement runs $650 to $1,200. The range depends on the brand, the part, and whether the gate itself needs adjustment before the motor will work right. You’ll get a written price before any work starts, and the diagnostic is waived if you approve the repair. Call (888) 292-7536 for an exact quote – estimates are free.
Yes, we’re certified to service nine major brands, including LiftMaster and DoorKing. We know their control boards, receivers, and the wear points that cause the most common failures. If you have a Linear, FAAC, BFT, Viking, Ghost Controls, Elite, or Mighty Mule operator, we service those too. Whether it’s a LiftMaster swing gate or a DoorKing slide gate, tell us the brand when you call and we’ll come prepared.
Yes, a live person answers the phone 24 hours a day, seven days a week, and same-day repair is often possible when you call in the morning. If your gate is stuck open and your property is exposed, call right away – that’s a security problem, not just an inconvenience. We’ll tell you honestly whether we can get to you today or whether it needs to be scheduled. For after-hours emergencies, the phone still gets answered.
Every job carries the 90-Day Done Right Promise in writing. If something we worked on isn’t right within 90 days, one call brings us back and we make it right – no runaround, no phone tree. The promise is stamped on the invoice, not buried in fine print. Manufacturer warranties on new operators pass through to you as well.
Clear the area around the gate and the operator so we can get to the unit safely, and make sure someone is home to let us in. If you have the operator manual or the model number, have it handy – it saves diagnostic time. Note what the gate does and when it started, and whether anything changed recently like a power outage or a storm. If you have a written estimate from another company, we’ll give you a free second opinion on it. See our home page for the full list of what we do, or our Gate Motor & Opener in Paradise page for more detail on this service. If the gate itself is damaged, our Gate Repair page covers that work, and Gate Access Control covers keypads and entry systems. For parts and on-site welding, see Gate Parts & Welding.
Schedule Your Gate Motor & Opener Service in Paradise Today
If your gate is stuck, slow, or making a noise it shouldn’t, call (888) 292-7536. A live person answers around the clock, the estimate is free and no-obligation, and you’ll get a written price before any work starts. Every job comes with the 90-Day Done Right Promise. Call today and tell us what the gate is doing.
Written by the team at Gatewood Fence & Gate.