Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Access Control Installation: The Paradise Owner’s Guide
Gatewood Fence & Gate Paradise installs Ghost Controls-compatible access control on residential and light-commercial gates in Paradise, with typical installed cost running $450 to $1,150 for a keypad, intercom, or telephone entry setup, depending on whether you need a new power run. Installation is scheduled, not same-day: access control has to be measured, matched to your operator, and priced in writing before anyone touches the gate.
Owners usually find out a Ghost Controls access control part has failed the same way. The keypad takes the code and nothing happens. Or the gate opens for the car but the entry panel has stopped waking the operator altogether. In Paradise, we see a lot of this on west-facing brick pillars where the afternoon sun bakes the control housing and the rubber keypad membrane goes brittle years before the electronics do.
Which Ghost Controls Models This Applies To
Ghost Controls builds its access control around the AXO, AXR, and TDS series operators, and the keypads, entry transmitters, and wired or wireless entry devices you’d pair with one are matched by series, not just by brand. A keypad built for a wireless AXO install won’t talk to a wired TDS control board the same way, so the model number on the operator’s control box (not the sticker on the arm) is what we check first in Paradise. It’s usually on a label inside the housing, along with the serial and the date code.
If the label is gone, we identify by measurement. Ghost Controls uses its own connector pinout and terminal spacing, so a keypad harness from another brand won’t seat cleanly. On the OEM-versus-aftermarket question for Ghost Controls specifically: the genuine keypad and entry units are worth it when you need the wireless pairing to work first time. Quality aftermarket equivalents can save real money on the lower-traffic stuff, but we tell Paradise owners up front which ones hold up in our desert heat and which ones don’t.
We’re an independent service provider. Gatewood isn’t affiliated with Ghost Controls, and we don’t claim to be. What we do is service the brand alongside eight others – LiftMaster, Mighty Mule, and DoorKing included – and we’ve learned which Ghost Controls parts fail here and which ones keep going.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your Ghost Controls Access Control Installation Is Failing
- Keypad accepts the code but the gate doesn’t move. The entry device is sending, the operator isn’t receiving – usually a failed wireless receiver or a corroded terminal at the control board.
- Membrane keys feel mushy or need a hard press. The rubber keypad has UV-degraded and the internal contact pad is wearing through. Common on sun-facing Paradise installs after about five to seven years.
- Intermittent entry only in the afternoon. Heat pushes a marginal solder joint or a tired relay across the line, so the panel works in the morning and quits by two o’clock.
- Wired entry device shows no power. Could be the entry unit, could be the low-voltage power run, could be the transformer. We test all three before quoting a part.
- Gate opens but won’t close from the entry device. Often a safety edge or loop issue mistaken for an access control fault, which is why we troubleshoot the whole circuit, not just the part you can see.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
| What you’re getting | Installed price in Paradise |
|---|---|
| Wireless keypad or entry transmitter replacement | $450 – $600 |
| Wired keypad or intercom with existing power run | $650 – $900 |
| New entry device plus fresh low-voltage power run | $900 – $1,150 |
What drives the range: whether the power run is already there and healthy, whether you’re pairing a new entry device to an existing operator or replacing both, and how much digging a fresh conduit run needs along a masonry pillar. Parts and labor are itemized, not bundled into a number you can’t check. The price is quoted and agreed before any work starts, and every job carries our 90-Day Done Right Promise in writing.
DIY or Call Us?
You can safely do a few things yourself. Check the keypad batteries, confirm the operator still responds to a remote, and look for a tripped breaker or a pulled low-voltage wire at the transformer. That’s diagnosis, not repair.
Where it goes wrong is wiring a new entry device into the control board. Ghost Controls uses low-voltage wiring, but there’s still live power at the operator and a gate that can move without warning while your hands are inside the housing. A mis-pinned harness can fry the board and cost you more than the keypad did. If you’re not certain the connector matches your series, that’s the point to stop. Call us at (888) 292-7536 for a free second opinion on any written estimate before you buy a part that may not fit.
FAQs
A Ghost Controls keypad or entry transmitter typically gives six to eight years in mild conditions, and closer to four to six on a sun-exposed pillar in Paradise. The electronics often outlast the keypad membrane, which is why we check both before recommending a full swap.
Often, yes. A keypad membrane, a corroded terminal, or a loose wire can be repaired on site and save you the cost of a new unit. We repair first and only recommend a replacement when the part is genuinely past saving – that’s how we’ve run the shop since 2001. Call (888) 292-7536 for a straight answer on your specific panel.
A like-for-like keypad or entry transmitter replacement is usually a one- to two-hour job once we’re on site. A fresh power run takes longer, and we’ll tell you the window up front so it doesn’t turn into an all-day surprise. The install itself is scheduled after a measure and a written price, not dispatched same-day.
We source the correct Ghost Controls-compatible part by your operator’s series and serial, not by a guess off a photo, and we tell you in Paradise whether OEM or a quality equivalent is the smarter buy for your traffic and sun exposure. No part shows up on a truck – it’s ordered to fit, and the price is agreed before we start.
If your Ghost Controls entry device is failing, don’t guess at the part. Call Gatewood Fence & Gate Paradise at (888) 292-7536 for a free estimate. We’ll identify the correct part for your model, price it in writing, and stand behind the work with our 90-Day Done Right Promise.
Written by the team at Gatewood Fence & Gate Paradise, serving Paradise and nearby areas.