A Gatewood company - serving Paradise, NV

DoorKing Keypad & Intercom Repair in Paradise, NV

Wrought ironWrought iron
Wood & steel frameWood & steel frame
Farm & ranchFarm & ranch
Sliding driveway gatesSliding driveway gates
LiftMaster operatorsLiftMaster operators
Every visit starts with

Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted

The assessment is free and the quote is the invoice.

Get your free estimate

DoorKing Keypad & Intercom Repair: The Paradise Owner’s Guide

Repairing a failed DoorKing keypad or intercom in Paradise usually runs $185 to $420 installed, depending on whether we’re replacing a keypad, an intercom station, or the control board behind them – and yes, most of these get handled same day. The typical call comes from a homeowner standing at the pedestal at 7 a.m. with a gate that won’t buzz them in, or one where the keypad lights up but the code does nothing. Sometimes the intercom crackles like a drive-thru speaker. That’s when the phone rings.

Call (888) 292-7536

Key takeaways:

  • Most Paradise keypad and intercom failures are power, wiring, or water intrusion – not a dead unit.
  • Installed repair runs $185 to $420, quoted before we touch anything.
  • Same-day service is common; parts for older DoorKing series may need a day to source.

Which DoorKing Models This Applies To

DoorKing has been building access control since the 1950s, and the units in Paradise run the full spread – older 1812 and 1833 slide gate operators with standalone keypads, up through the 6000 and 6400 series swing operators with integrated entry systems, and the 1500-series telephone entry units mounted on a gooseneck pedestal at the driveway. The keypad line alone splits into flush-mount and surface-mount, 26-bit Wiegand output versus older 8-bit, and standalone versus system-integrated. Get that wrong and you’re installing a pad that speaks a language your controller doesn’t.

To identify what you’ve got, look for the data plate inside the operator housing or on the back of the keypad faceplate – DoorKing puts the model and serial there. Failing that, measure the faceplate: a 3.5-inch by 5-inch pad is a different animal than the larger entry-system keypads. On the OEM-versus-aftermarket question, DoorKing’s own parts are the safe call for anything integrated into a telephone entry system, where firmware and communication protocol matter. For a simple standalone keypad, a quality aftermarket pad with matching output will do the job at half the price. We’ll tell you straight which camp your unit falls into.

Explore

Styles & brands we work with

  • Wrought iron
  • Wood & steel frame
  • Farm & ranch
  • Sliding driveway gates
  • LiftMaster operators

Signs Your DoorKing Keypad & Intercom Repair Is Failing

  • Keypad lights on, codes do nothing. The pad has power but isn’t talking to the control board – usually a bad data line, a corroded terminal, or a controller that lost its programming after a power blip. Paradise’s summer brownouts are hard on these boards.
  • Intermittent buzzing, then nothing. Classic water intrusion. Our monsoon humidity and the dust that follows it work into the gasket and the pedestal seam, and the contacts corrode from the inside.
  • Intercom crackles or cuts out mid-sentence. The speaker or microphone element is failing, or the telephone line feeding the entry system has noise on it. Older 1500-series units are notorious for this once the element ages out.
  • Code works for one person, not another. Not a hardware fault – a programming or memory issue. Sometimes the board’s memory is corrupted, sometimes a code got wiped. Worth checking before replacing anything.
  • Gate opens on its own or won’t release. The keypad is sending a stuck signal, or a relay on the control board has welded shut. That one is a safety issue – don’t ignore it.

A quick word on safety before we go further: the low-voltage side of a DoorKing keypad is genuinely safe to look at, but the moment you’re inside the operator housing you’re near 120-volt line power and, on slide gates, high-tension chains and springs under load. That’s not a place to poke around with a screwdriver and a flashlight. Electrical work and anything touching the gate’s moving mechanism belongs with someone trained for it.

Replacement Cost & What’s Included

In Paradise, a standalone keypad swap typically lands between $185 and $260 installed. An intercom station replacement or a telephone entry board runs $240 to $420, because the diagnostic work is deeper and the parts cost more. What moves you up or down the range: whether the wiring is sound, whether the pedestal needs re-sealing, whether the controller needs reprogramming, and whether the part is in stock locally or has to be ordered.

Job Typical installed price in Paradise
Standalone keypad replacement $185 – $260
Keypad wiring repair / terminal rebuild $150 – $220
Intercom speaker or microphone element $200 – $310
Telephone entry board replacement $280 – $420
Control board relay / programming reset $165 – $245

Every price is quoted and agreed before any work starts – no surprises at the door. Every job carries the 90-Day Done Right Promise in writing, so if something acts up after we leave, one call brings us back.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

DIY or Call Us?

What you can safely do yourself: check that the keypad has power, look for obvious water damage or a loose faceplate, confirm the breaker feeding the operator hasn’t tripped, and re-test a known-good code. That’s the low-voltage, outside-the-box stuff, and it’s fine.

Where DIY goes wrong on DoorKing gear is everything past that point. Programming a replacement pad to talk to an existing controller requires knowing the output type and, on entry systems, the communication protocol. Swapping a control board means working beside 120-volt line power. And if the failure is actually a stuck relay that’s holding the gate open, “just replacing the keypad” doesn’t fix it and you’ve spent money for nothing. We see this constantly in Paradise – a homeowner buys a pad online, it doesn’t match the controller, and now they’ve got two problems.

Call (888) 292-7536 and we’ll sort out what’s actually failing before you buy anything. A live person answers, around the clock.

FAQs

Get It Fixed Right

If your DoorKing keypad or intercom has quit on you in Paradise, don’t guess at the part – let us diagnose it first. Our technicians have up to 25 years of experience on these systems, and every call is answered by a live person, 24/7. Standing offers include no trip charge inside the county, $40 off any repair over $200, a free second opinion on any written estimate, and a permanent 10% discount for seniors and veterans. Call (888) 292-7536 for a free estimate – we’ll get you a straight answer and a price that holds.

Written by the team at Gatewood Fence & Gate Paradise, serving Paradise and nearby areas.

Need Gate Repair help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (888) 292-7536
Local Service Coverage

Request a Free Estimate in Paradise

Tell us what you need - Gatewood Fence & Gate Paradise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch