Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Motor & Opener in Paradise: What to Know First
We provide independent Ghost Controls gate motor and opener service in Paradise, and most repair calls are handled same day. We’re an independent Ghost Controls service provider, not affiliated with or authorized by Ghost Controls, and our pricing is quoted and agreed before any work starts. If your Ghost Controls operator is dead, sluggish, or opening on its own, call (888) 292-7536 and a live person answers, day or night.
This page is for the Paradise homeowner with a Ghost Controls arm or slide operator on a driveway gate, a side-yard gate, or a small ranch entry. You bought Ghost Controls because the price was fair and the install was something a handy neighbor could follow. Now it needs a real diagnosis. Our technicians have up to 25 years of experience, and they know these units.
How Ghost Controls Products Fail – and How We Fix Them
Ghost Controls units are built for DIY-friendly installation, and that’s exactly where a lot of the trouble starts. Here are the five failures we see most in Paradise.
- Control board corrosion on the LCR and TDS series. The circuit board sits in an enclosure that collects dust and morning moisture, and once the terminals fur up, the operator starts behaving erratically: opens halfway, stops, reverses. Ghost Controls sells replacement boards, but a board alone won’t fix it if the enclosure is taking on water. We reseal the housing, clean and torque the terminals, and replace the board only when it’s actually failed.
- Battery backup dying in the summer heat. The AXS and TSS units lean on a backup battery, and Paradise summers cook them. A two-year-old battery can test fine on a meter and still fail under load when the gate is heavy. We load-test the battery under real gate resistance, not just voltage, and swap it if it can’t hold.
- Swing arm binding and false obstruction trips. The arm operator is strong, so when the gate hinge sags, the unit keeps pushing until it times out or reverses. The gate usually needs a hinge repair, not a new arm. Fix the panel without the post and you’ll fix it twice, so we check the post and hinge before touching the motor.
- Limit and sensitivity settings drifted after a power blip. Ghost Controls units are sensitive to gate weight changes and small travel adjustments, and a few summers of heat expansion can throw the limits off. Re-teaching the open and close points is often a ten-minute fix.
- Wiring and photo-eye faults at the gate. Underground low-voltage runs get nicked by shovels, gophers, or sprinkler work, and a single bad splice kills the whole operator. We trace the run before we replace anything, because the motor is usually fine.
If your unit is newer and the board and motor both look good, the problem is almost always in the gate itself, the wiring, or the battery. That’s true of Linear and Mighty Mule units too, which is why we service those alongside Ghost Controls.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Our Ghost Controls Gate Motor & Opener Process
Here’s how a Ghost Controls job runs from your first call to the moment we pull out of the driveway.
- 1
You call and get a live person. We ask what the gate is doing, what model you have if you know it, and when it last worked. If it’s a safety issue, we treat it as one.
- 2
We come out and diagnose. We check the gate, post, hinges, wiring, photo-eyes, battery, and control board in that order. The motor gets blamed last, because it usually isn’t the problem.
- 3
We give you a written price before we touch anything. The number on the estimate is the number on the invoice. No surprises at the door.
- 4
We repair, and we weld on site if needed. A sagging hinge or a cracked mount gets welded in your driveway. The gate stays where it belongs.
- 5
We use OEM Ghost Controls parts when they’re the right call, and quality aftermarket when they’re better. We’ll tell you which and why, and we keep the job within warranty where the manufacturer’s terms allow.
- 6
We test the full cycle and clean up. Open, close, obstruction test, battery test, and a walk-through with you. Every job carries the 90-Day Done Right Promise in writing.
See the difference
Before
After
Before
After
Before
AfterWhat Ghost Controls Gate Motor & Opener Costs in Paradise
Every price is quoted and agreed before work starts, and we don’t change it at the door. Here’s what Paradise homeowners typically see:
| Job | Typical Price Range |
|---|---|
| Diagnostic visit (applied toward repair) | $75 – $125 |
| Battery backup replacement | $90 – $180 |
| Control board replacement | $180 – $320 |
| Limit and sensitivity re-teach | $75 – $150 |
| Photo-eye or wiring repair | $120 – $280 |
| Swing arm or slide motor repair | $200 – $450 |
| New Ghost Controls operator installed and tested | $700 – $1,600 |
What moves the price: gate weight and condition, whether the wiring is sound, how far the operator sits from the house, and whether the mount needs welding. If you have a written estimate from another shop, we’ll give you a free second opinion. Seniors and veterans get a permanent 10% discount, and there’s a $40 credit on any repair over $200.
Why Paradise Homeowners Call Gatewood Fence & Gate Paradise for Ghost Controls Work
We’ve been locally owned and owner-operated since 2001, so the name on the shop is the name on the invoice. That’s the oldest accountability there is. Our crew is background-checked and uniformed, and we service nine major gate brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. If your neighbor has a LiftMaster down the street or a Mighty Mule on the back gate, we handle those too.
The 90-Day Done Right Promise is in writing on every job. If something’s not right, one call brings us back. Calls are answered by a live person, 24/7, and there’s no trip charge inside the county. We fix what’s broken instead of selling you a new operator you don’t need.
FAQs
Yes. We repair out-of-warranty Ghost Controls units in Paradise regularly, and we use OEM parts where they matter for proper fit and function. Call (888) 292-7536 for an exact quote; estimates are free.
Battery backup runs $90 – $180, and a control board replacement runs $180 – $320, parts included. The final price depends on the model and whether the enclosure needs resealing. Call (888) 292-7536 for an exact quote; estimates are free.
Yes, in most cases. Ghost Controls repair calls in Paradise are usually handled same day, and we answer the line around the clock. Call (888) 292-7536 and we’ll tell you honestly when we can be there.
Repair is usually cheaper and faster unless the motor itself has failed. On Ghost Controls swing and slide units, boards, batteries, photo-eyes, and wiring are all repairable, and replacing a whole operator for a $150 fix doesn’t make sense. We check the gate first, then the wiring, then the motor. Call (888) 292-7536 for a free second opinion on any written estimate.
New operator installs are measured and scheduled, not same-day, because the gate, mount, wiring, and safety edges all need to match the unit before we order. We come out, measure, and give you a written price first. Call (888) 292-7536 to get on the schedule.
Yes. We handle the low-voltage wiring, the power run, and the safety photo-eyes as part of the install, and we test the full cycle before we leave. Call (888) 292-7536 for a free estimate.
Whether your Ghost Controls gate needs a battery, a board, or a fresh install, we’re one call away. We’re locally owned and owner-operated, we answer the phone 24/7 with a live person, and every job is quoted upfront before we start and backed by our 90-Day Done Right Promise. Call (888) 292-7536 for a free estimate in Paradise today.
Written by the team at Gatewood Fence & Gate Paradise, serving Paradise and nearby areas.